The WAC Lighting EN-24100-RB2-T is an enclosed Class 2 remote transformer built specifically for InvisiLED tape light. It steps 120V line power down to 24VAC to drive InvisiLED Lite, Pro, Pro 2 and Pro 3 runs, and its enclosed housing with line-voltage knockouts lets it be mounted remotely in a cabinet, closet, soffit or ceiling space. It suits kitchens, cove lighting, bars and back bars, retail fixtures, hotel casework and office millwork where a clean, hidden power supply is needed.
Key Features
- 120 VAC, 50/60 Hz input, 24VAC output for InvisiLED tape systems
- 100 watt maximum output rating (WAC's model description lists 96 watts)
- Electronic low voltage (ELV) dimming from 100% to 10%
- 1 watt minimum load
- Knockouts on three sides with clips for line-voltage wiring
- Built-in auto reset, soft start, short circuit and overload protection
- Class 2 output limited to 5 amps, so secondary wiring needs no conduit or sheathed cable
- UL, cUL and damp location listed, black finish, 5 year WAC warranty
Ideal Applications
Powering InvisiLED tape under kitchen and bath cabinets, in coves and toe kicks, along shelving and display cases, behind bar fronts and in hospitality and retail millwork.
Compatibility
Made for WAC InvisiLED Lite, Pro, Pro 2 and Pro 3 24V tape light. A 60W version, EN-2460-RB2-T, is available for shorter runs. Dims with an electronic low voltage (ELV) dimmer.
Frequently Asked Questions
Which dimmers work with this transformer?
Use an electronic low voltage (ELV) dimmer. WAC rates the dimming range at 100% to 10%.
Can I install it in a damp location?
Yes. WAC lists it as damp location listed, which suits spaces such as bathrooms and covered areas that see humidity but not direct water. It is not a wet-location product.
How much tape light can it run?
Add up the wattage of your InvisiLED runs and keep the total at or below the transformer rating. Many installers leave headroom below the maximum for long-term reliability.
Do I need anything else to finish the install?
You need the InvisiLED tape, connectors, a 120V supply and, if dimming, an ELV dimmer. A qualified electrician should make the line-voltage connections per the NEC and local code.