The Chief FCA106 finishes off a Fusion wall mount installation by closing in the open sides between the display and the wall. Each cover runs 24 inches tall and is only 0.39 inch thick, so it tucks in neatly beside the screen and screens off cable runs, wall plates and mounting hardware that would otherwise be visible from an angle. The covers are made from a flexible material and stay in place when the mount is tilted. Installation takes two steps: swap in the modified end caps supplied with the kit by screwing them onto the mount, then clip the covers into place. The kit includes two covers and two end caps, enough to dress both sides of one mount. Because the covers are 24 inches tall, Chief specifies them for displays taller than 24 inches so the cover stays hidden behind the screen.
Key Features
- Conceals cables and mount hardware
- Stays on in tilt mode
- Clip-in cover with screw-on end caps
- 2 covers and 2 end caps included
- Low 0.39 in (10 mm) profile
Ideal Applications
Lobbies, retail, hospitality and conference rooms where Fusion-mounted displays are seen from the side and a clean, finished look matters.
Compatibility
Compatible with all Chief Fusion fixed and tilt wall mounts. Display must be taller than 24 in (61 cm). Mount and display sold separately.